Supported Test Module Options
MPM-600G
6x Port 100G QSFP28 Multi-Protocol Module
The MPM-600G Multi-Protocol Module is an advanced multi-port QSFP28 test module for high density 40/100G and next-generation OTUCn & FlexE applications.
- Advanced 6x QSFP28 port module for next-generation test applications
- Supports 6x fully independent 40/100G tests. Each port may support independent user, port rate, protocol mode, and transmit reference clock
- The MPA® chassis supports up to 2x MPM-600G test modules which provides 12 independent 40/100G test ports in a 1U chassis
- Provides advanced test mode operation for next generation applications such as OTUCn and FlexE which require multiple PHY ports to be used in parallel for a single test application
- Advanced and flexible FPGA based test module provides future proof hardware support for emerging standards and test applications
- The advanced pluggable hardware module supports easy field installation in deployed MPA chassis with existing test modules
Ethernet/IP Traffic Generation & Analysis
- 100GE, 100GE IEEE 802.3bj Clause 91 RS-FEC for SR4, & 40GE
- Full line rate layer 1-4 multi-stream, throughput, frame loss, latency, packet jitter, and BERT characterization
- PCS & RS-FEC layer testing
- RFC 2544 & Y.1564 compliance testing
- Service disruption time (SDT) measurement
OTN Traffic Generation & Analysis
- OTU4, OTU3, OTU3e2 & OTU3e1
- OTL, FEC & OTN layer testing
- Complete overhead/trace generation and analysis with byte capture
- Thru mode with error & alarm stimulus testing
- Service disruption time and delay measurements
OTCn Traffic Generation & Analysis
- OTUCn (n=1-6)
- OTLC.n, FEC & OTUCn layer testing
- Complete overhead/trace generation and analysis with byte capture
- Service disruption time and delay measurements
FlexE Traffic Generation & Analysis
- Testing of FlexE Shim/Calendar, MAC clients and 100GBASE-R PHY
- 5G, 10G, 40G & Nx25G (25G, 50G, 75G, 100G) MAC client
- MAC client rate analysis
- Shim and calendar layer control/testing
- FlexE overhead and multi-frame manipulation with error/alarm generation and detection
- Intrusive Pass Thru mode allows FlexE Shim overhead layer errors and alarms to be inserted into live network traffic for error/alarm response testing
Physical Layer Analysis
- QSFP28 transceiver verification
- High speed lane clock stressing/analysis and optical power level verification
- Unframed BERT for signal integrity testing
- Transceiver module health check feature
- Transceiver I2C read/write testing
- QSFP28 module 3.3V power adjustment and monitoring
Brochures
Release Notes
Software
Attention: DO NOT downgrade the software version currently installed in your test platform or module, unless specifically instructed by a VeEX Customer Care/Support agent. Your new test set may have been shipped with a newer version. For software upgrades, please check the current version(s) on your test set to confirm that the software posted here is a newer version and carefully read the Release Notes for the recommended platform versions.
Specification Sheet
Technical Notes
User Manuals
| Request a Demo | Contact Sales |
| Request a Quote | Financing |
| Register a Product | Locate a Partner |