MTTplus-340
Advanced Multi-Service Test Module
The MTTplus-340 test module offers advanced test solutions for Access, Metro and Carrier Ethernet, supporting OTN, SONET/SDH, PDH/DSn, Fibre Channel, CPRI, C37.94 and Synchronization. This compact and flexible test platform helps service providers increase efficiency and productivity. It lowers OpEx and CapEx associated with handling multiple technologies required to address today’s Access, Business, Carrier Ethernet, Transport and Core services.
- Flexible, all-in-one multi-service test solution, from 64 kbps to 14 Gbps
- Transport, Core, Metro, SAN, Backhaul, Fronthaul and Network Synchronization
- Offers two fully independent test ports for simultaneous measurements
| Test Interfaces (per module) | ||
|---|---|---|
| Ports | Technology | Rates |
| 2 SFP+/SFP | Ethernet Fibre Channel OTN SDH SONET CPRI IEEE® C37.94 |
10GBASE-X, 1000BASE-X, 100BASE-FX, 10GBase-T, 5G Base-T, 2.5GBase-T 16G, 10G, 8G, 4G, 2G, 1G FC OTU2e, OTU1e, OTU2, OTU1 STM64/16/4/1/0, OC192/48/12/3/1 12.168G down to 614.4M 64k to 768k |
| 2 RJ45 | Ethernet | 1000/100/10Base-T |
| 3 BNC2 | SDH/SONET PDH/DSn |
STM1/0, STS3/1 E4, E3, E2, E1, T3 |
| 1 RJ481 | PDH/DSn | E1, T1, 64K Codirectional |
| 2 SMA | Clock (Ext.) | 1PPS, 1.544/2.048/10 MHz, 2.048 Mbps, 1.544 Mbps |
1Balanced ports available in RJ48 or Bantam connector.
2Tx1, Rx1, and Rx2. Rx2 port may be available for monitoring applications.
Ethernet
- RFC 2544 Throughput, latency, frame loss and back to back tests
- V-SAM test suite compliant with ITU-T Y.1564 standard
- IEEE 802.3ah, ITU-T Y.1731, IEEE 802.1ag, MPLS-TP OAM support
- Q in Q (VLAN stacking), MPLS, MPLS-TP, PBB support
- RFC 6349 V-PERF TCP/UDP test suite
- Layer 2 Control Protocol Transparency test
- Advanced tests: IP Sec, LACP, L2CP, NAT Traversal
- In-service monitoring with packet capture and on-screen protocol decode
- One way latency with optional built-in GNSS receiver
- Fully integrated solution for synchronized packet networks
- Supports SyncE/ITU-T G.8261 standard
- Master Clock and Slave clock emulation
- Wander measurement and MTIE/TDEV analysis
- SyncE ESMC SSM generation, monitoring, and decoding
- VoIP and IPTV testing
Fibre Channel
- Storage Area Networks (SAN) testing up to 16G FC
- BERT, Throughput, and RFC 2544 test
- RFC 2544: Throughput, latency, frame loss, back to back tests
- In-service monitor, capture and protocol decode
- Layer 1 and layer 2 loopbacks
CPRI Testing
- Common Public Radio Interface standard (CPRI) Layer 2 tests (REC/BBU and RE/RRH emulation)
- BER testing with PRBS stress patterns
- Latency measurements
OTN/SDH/SONET/PDH/DSn
- Advanced flexible OTN, SDH/SONET, PDH/DSn test payload map/mux, including EoOTN (ODU2e, ODU0 and ODUflex)
- Overhead Monitoring and Byte decoding
- Protection Switching and Service Disruption Time (SDT)
- Round Trip Delay on all interfaces and payload mappings
- Tandem Connection Monitoring
- Jitter and Wander (E1, E3, DS1, DS3, STM-1o, OC-3)
- Pulse Mask Analysis at E1, E3 and DS1, DS3 rates
IEEE C37.94™
- Power/Utilities Teleprotection Network testing
- BERT, SDT/APS, RTC and transparency tests
- Passive bidirectional Monitoring and intrusive Pass-Through modes
- GNSS-assisted One-Way-Delay measurements
- Jitter and Wander Measurements
Brochures
Release Notes
Software
Attention: DO NOT downgrade the software version currently installed in your test platform or module, unless specifically instructed by a VeEX Customer Care/Support agent. Your new test set may have been shipped with a newer version. For software upgrades, please check the current version(s) on your test set to confirm that the software posted here is a newer version and carefully read the Release Notes for the recommended platform versions.
Specification Sheet
Technical Notes
User Manuals
| Request a Demo | Contact Sales |
| Request a Quote | Financing |
| Register a Product | Locate a Partner |
LOCAL PARTNERS
INFORMATIONAL DOWNLOADS
Advanced C37.94 Pass-Through
Testing Technical Note
